
Maytoni
Maytoni 48V magnetic track power supply 150W grey TRA004DR-150S
TRA004DR-150S is a 150 W driver for Maytoni's 48 V magnetic track system. A metal housing 15.9 × 9.7 × 3 cm, AC 100-260 V in, 48 V out. Without it the track does nothing A magnetic track does not run on mains voltage: magnetic fittings are not connected to 230 V but to a safe **48 V**, and converting one to the other is exactly what this driver does. It is a separate catalogue item — buying a track and fittings means buying a driver of adequate power as well. The arrangement has a practical consequence too: the voltage on the track is low, so the rails themselves pose no touch hazard and fittings can be repositioned without switching the circuit off. 150 W is the power budget for the whole track Choosing a model comes down to arithmetic: add up the wattage of every fitting that will hang on one run and pick a driver with headroom. This one gives **150 W**, which with typical 6–18 W magnetic spots will serve a dozen or more points. Maytoni offers the same housing in four ratings — **TRA004DR-100S** (100 W), **150S**, **200S** and **320S** — so extending an installation usually means changing the driver, not the whole system. It is not worth sizing it exactly to the calculated sum: a driver running near its maximum gets hotter and lives less long. Where to hide it The housing measures 15.9 × 9.7 cm at just **3 cm high** — designed to fit in the void above a suspended ceiling, in a service box or inside cabinetry. It weighs 0.4 kg. **IP20 means it must go somewhere dry and enclosed**, not outdoors and not into a bathroom protection zone. The metal case works as a heatsink, so it should not be wrapped in mineral wool or shut into a sealed box without ventilation. Electrical data and limits The input takes a wide **AC 100-260 V** range, which makes the driver tolerant of mains fluctuation. It works in protection class I and requires an earth conductor. The driver itself is **not dimmable**: brightness control in a magnetic system happens at the fittings or through a dedicated controller, not by putting this module on a phase-cut dimmer. Maytoni covers the product with a **five-year warranty**. It contains no light source of any kind — it is purely a supply component. Specification Manufacturer: Maytoni Collection: Power supplies 48V Series: Power Supply Magnetic Article: TRA004DR-150S Type: driver for magnetic track System: 48 V magnetic Power: 150 W Input voltage: AC 100-260 V Output voltage: 48 V Length: 15.9 cm Width: 9.7 cm Height: 3 cm Material: metal Colour: grey Ingress protection: IP20 Protection class: I Dimming: no Net weight: 0.4 kg Gross weight: 0.42 kg Warranty: 5 years EAN: 4251110047966Visa mer
Erbjudande
Alla priser inkl. moms; frakt enligt butikens feed. Klicket leder direkt till produktsidan i butiken.
Prisutveckling (lägsta pris)
Prisbevakning
Meddela mig när den här varan sjunker i pris.
Produktdetaljer
- Märken
- Maytoni
- GTIN
- 04251110047966
- Kategorier
- Hem och trädgård > Belysning > Belysningsskenor > Tillbehör till belysningsskenor
Liknande produkter
Power Supply 48V - 150W Plug-in to LUNA-MAG Busbars Black - LUNARES1 erbjudandefrån 801,00 kr
Pendant Lamp Adapter SLV 1 SYSTEM Black 1431201 erbjudandefrån 183,39 kr
1-Phase Track Adapter SLV 1 SYSTEM black 1431701 erbjudandefrån 183,39 kr
Zaleplepka 9004 / W STUCCHI white, black, gray1 erbjudandefrån 41,28 kr
Eutrac Lighting Bus T Switch Right Silver Grey 230 V1 erbjudandefrån 2 040,00 kr
Ändlock för Stucchi ONETRACK-skena 9004/TR-B svart1 erbjudandefrån 137,25 kr