Lumines

End cap for LUMINES C LED profile, black, without hole

Name: End cap for LUMINES C LED profile, black, without hole
Brand: Lumines

The LUMINES end cap, article number 12-0042-01, closes the end of an LED profile from the C system. It is made of black ABS and pushes into the profile section — no screws and no glue. Which profile it belongs to Profile C is a corner profile with a triangular section for surface mounting, with the LED strip set at 45 degrees. The cap reproduces exactly that section, and Lumines end caps are tied to one system — a part from another profile will not close profile C. Which variant goes on which end This is the version without a hole, the blind one: a supply cable cannot be led through it. For the end where the supply enters, Lumines makes a separate cap with a hole — in black ABS it carries the number 12-0042-00. Closing one run of profile therefore usually calls for two different parts: the blind cap at one end and the drilled one at the other. The same pair is also made in aluminium, as 12-0042-11 without a hole and 12-0042-10 with one, so the ends can be matched to the material of the profile itself.Meer tonen

vanaf € 0,47

1 aanbieding

Bekijk aanbiedingen