NORLYS

NORLYS Narvik II 1852GR LED bollard light 3000 K, graphite RAL 7016, 95 cm

Name: NORLYS Narvik II 1852GR LED bollard light 3000 K, graphite RAL 7016, 95 cm
Brand: NORLYS

NORLYS Narvik II 1852GR is a 95 cm outdoor bollard light with a rounded cap and a clear light opening beneath its upper shield. The body is powder-coated cast aluminium in graphite RAL 7016, while the transparent cover is made from PMMA. Its upright proportions and distinct head suit Scandinavian and modern exterior design without relying on decorative scrollwork.Warm light around the bollardThe included LED module produces warm-white light at 3000 K. Light exits in four directions and is shielded from above. This matters when laying out a scheme around paths or open areas: the fitting illuminates its surroundings rather than directing a narrow spotlight beam at one selected object.Complete luminaire output is 1416 lm at a total power of 22.2 W. That output is the light leaving the fitting, not the higher flux produced by the LED module before the optical system. This version is non-dimmable, so plan for on/off operation rather than brightness adjustment through a dimmer.Allowing room beside a pathThe manufacturer specifies use in private grounds and public areas. Suitable layouts include pedestrian routes, parks, driveways and the outdoor grounds of hotels or restaurants. Width and depth are both 24 cm. Compare those dimensions with the available space beside a walkway or terrace before positioning the base, keeping the body outside the route used by people or vehicles.IP65 ingress protection and IK10 impact resistance are confirmed for this fitting. The number of bollards and the spacing between them should be determined from the site layout and photometric data, rather than wattage alone. A single output figure cannot establish the coverage of a particular installation.Installation and service accessThe base has six oval fixing holes measuring 10 × 15 mm, spaced at 60° around a 172 mm pitch circle. Installation and connection to a 220–240 V supply must be carried out by a suitably qualified professional following the mounting instructions. The concrete anchor and mounting adapters are sold separately and must be selected for the prepared support.The LED module and electronic driver are included. Both the light source and control gear are replaceable by professional service personnel; this is not a fitting for a standard user-replaceable bulb. An inspection door in the body provides the access built into the bollard design.Show more

from €1,256.64

1 offer

See all offers