
LED Labs
LED Strip OPTI 12V 2400 LED COB 10W/m 3000K CRI90 IP20 Warm White, 5 m reel
This is a five-metre reel of COB LED strip from LED Labs' OPTI series. Instead of individual diodes spaced several millimetres apart, a COB strip carries a phosphor layer running the whole length - it lights as a continuous, even line, with no visible points and none of the dotting a strip normally casts on a wall or inside a profile. Why COB rather than SMD On an SMD strip the separate diodes are visible, and if the profile is shallow or the cover sits too close, a row of bright points reflects onto the wall. COB (Chip on Board) solves that physically: 480 tiny emitters per metre - 2400 across the reel - sit under one shared phosphor layer. The result is a line of light that can be built into a very shallow aluminium profile without a frosted diffuser. It shows in ceiling coves, under kitchen cabinets and in shadow-gap trims, where the strip is seen at an angle. Light output The strip gives 850 lumens per metre for 10 W, an efficacy of 85 lm/W. The whole reel is about 4250 lm - enough to light a kitchen worktop end to end or outline the ceiling of a medium room. At 3000 K the light is warm and calm, and colour rendering exceeds 90, which is still not standard in LED strip; the declared red component R9 is 42. At that CRI, wood, brick and fabric keep their real colour - which is why this series goes into furniture and display lighting rather than purely technical installations. Supply and control The strip runs on 12 V DC and needs a separate driver - LED Labs does not include one with the reel. A full reel draws 50 W, so the driver is chosen with at least 20% headroom: 60 W minimum at 12 V, that is 5 A. At 12 V the voltage drop over a long run is more pronounced than at 24 V, so feed a five-metre length from one end, and wire two such lengths in parallel to the driver rather than in series one after the other. Dimming is possible but only with a dedicated 12 V PWM controller - not with a 230 V wall dimmer. Cutting and mounting The strip can be shortened every 25 mm at the marked points - a fine enough pitch that fitting a given recess rarely calls for a compromise. It is 8 mm wide and 3 mm thick, so it goes into most standard aluminium profiles. The underside carries factory-applied double-sided Blue Tape; the surface must be degreased before sticking, and inside an aluminium profile the adhesive is a helper rather than the fixing. The carrier is PCB laminate with 2 oz copper - twice the thickness of cheap strip; heavier copper carries heat away better, which feeds straight into diode life. Lifetime, sealing and warranty The manufacturer quotes 35,000 hours to L70/B50 - meaning that after that time half the samples still hold at least 70% of initial output. At three hours a day that works out at roughly 31 years. The strip takes over 30,000 switching cycles and runs from -20 to +45 °C. IP20 means no moisture protection at all: this strip belongs in dry interiors only - for a bathroom, outdoors or a worktop beside a sink, pick the IP65 or IP65 HS version of the same series. The warranty is 3 years. Variants The same OPTI 12 V 2400 LED COB 10 W model comes in three colour temperatures: 3000 K (this version), 4000 K and 6500 K. The series also runs to IP65 and IP65 HS equivalents. The strip is sold in full five-metre packs. SpecificationManufacturer index: 16-2318-01, OPTI seriesEPREL number: 1279166, energy class GLED type: COB (Chip on Board), 480 diodes per metre, 2400 per reelSupply: 12 V DCPower: 10 W/m (50 W per 5 m reel)Luminous flux: 850 lm/m (4250 lm per reel)Efficacy: 85 lm/WColour temperature: 3000 K, warm whiteColour rendering: CRI ≥ 90 (R9 = 42)Ingress protection: IP20 - dry interiors onlyStrip dimensions: 8 mm wide, 3 mm thickCut section: every 25 mmBacking: PCB with 2 oz copper, Blue Tape adhesiveLifetime: 35,000 h to L70/B50, over 30,000 switching cyclesOperating temperature range: -20°C to +45°CReel length: 5 mWarranty: 3 years (36 months)Εμφάνιση περισσότερων
Προσφορά
Όλες οι τιμές με ΦΠΑ· έξοδα αποστολής σύμφωνα με το feed του καταστήματος. Το κλικ οδηγεί απευθείας στη σελίδα του προϊόντος στο κατάστημα.
Ιστορικό τιμής (χαμηλότερη τιμή)
Ειδοποίηση τιμής
Ενημέρωσέ με όταν πέσει η τιμή αυτού του προϊόντος.
Λεπτομέρειες προϊόντος
- Μάρκες
- LED Labs
- GTIN
- 05904405917039
- Κατηγορίες
- Σπίτι και κήπος > Είδη φωτισμού > Φωτισμός με ανίχνευση κίνησης
Παρόμοια προϊόντα
Nordlux Link Single Spot White – for the Link track system, GU10 max 35W, 350° turn, 90° tilt, 86109901Σύγκριση τιμών από 2 καταστήματααπό 22,00 €
Nordlux 86079901 X-Connector Hochvolt-Schienensystem-Komponente whiteΣύγκριση τιμών από 2 καταστήματααπό 26,20 €
Link Swivel connec. white NordluxΣύγκριση τιμών από 2 καταστήματααπό 26,20 €
Nordlux Smart Strip 3m 2210439901 Effektleuchte LED 3W Warm whiteΣύγκριση τιμών από 2 καταστήματααπό 55,65 €
LED PRO A MINI connector for single color COB 8mm 1-sided LED strips without wire1 προσφοράαπό 0,53 €
LED PRO G MINI connector for single color COB 8mm 2-sided LED strips1 προσφοράαπό 0,53 €