Dynacord

Dynacord L3600FD 2 Channel Live DSP Power Amplifier, Class H, 2x1700W at 4 Ohms, FIR Drive, 2U Rack

Name: Dynacord L3600FD 2 Channel Live DSP Power Amplifier, Class H, 2x1700W at 4 Ohms, FIR Drive, 2U Rack
Brand: Dynacord

The Dynacord L3600FD is a two-channel Class H power amplifier for live sound, rated at 2x 1700W into 4 ohms and stable down to 2 ohms. Each channel has onboard speaker processing with Dynacord FIR-Drive, so it can drive and tune a PA without a separate loudspeaker processor. Typical uses are club and venue PA, touring tops and subs, and rental stock. 2x 1700WInto 4 ohms2x 3000WInto 2 ohmsFIR-DriveOnboard DSP2URack height FeaturesTwo channels, 2x 1700W into 4 ohms, 2x 3000W into 2 ohmsBridged output of 6000W into 4 ohmsTrue 2 ohm stable output stageOnboard DSP per channel: PEQ, 31-band GEQ, crossover, limiters and output delayChannel grouping with group PEQ, GEQ and delayFIR-Drive linear-phase processingProtection against over-temperature, DC, HF, back-EMF and peak current, plus inrush limiting and turn-on delayFront-to-rear cooling with three-stage fansSet up and controlled with Dynacord system software SpecificationsOutput power, both channels driven2 ohm: 3000W, 2.7 ohm: 2500W, 4 ohm: 1700W, 8 ohm: 900WOutput power, single channel2 ohm: 3200W, 2.7 ohm: 2700W, 4 ohm: 1800W, 8 ohm: 950WBridged output4 ohm: 6000W, 8 ohm: 3400WOutput stageClass HFrequency response10 Hz to 21 kHz (±1 dB)Signal-to-noise ratio>109 dB (A-weighted)Voltage gain32 dBMaximum input level+21 dBuInput impedance20 kohm, active balancedCrosstalk< -80 dB (1 kHz, 100W into 4 ohms)Power consumption850W at 1/8 maximum output into 4 ohmsMains240, 230, 120 or 100 V, 50/60 Hz (factory configured)CoolingFront to rear, three-stage fansDimensions (H x W x D)88 x 483 x 462.4 mm, 2U rackWeight18.2 kgShow more

from £1,433.00

1 offer

See all offers