Dynacord

Dynacord L1300FD 2 Channel Live DSP Power Amplifier, Class AB, 2x600W at 4 Ohms, FIR Drive, 2U Rack

Name: Dynacord L1300FD 2 Channel Live DSP Power Amplifier, Class AB, 2x600W at 4 Ohms, FIR Drive, 2U Rack
Brand: Dynacord

The Dynacord L1300FD is a two-channel Class AB power amplifier for live sound, rated at 2x 600W into 4 ohms and stable down to 2 ohms. Each channel has built-in speaker processing with Dynacord FIR-Drive, so it can drive and tune a PA system without a separate loudspeaker processor. Typical uses are club and venue PA, touring sub and top amplification, and rental stock. 2x 600WInto 4 ohms2x 1000WInto 2 ohmsFIR-DriveOnboard DSP2URack height FeaturesTwo channels, 2x 600W into 4 ohms, 2x 1000W into 2 ohmsBridged output of 2000W into 4 ohmsTrue 2 ohm stable output stageOnboard DSP per channel: multi-band PEQ, crossover, limiters and delayChannel grouping with group PEQ, GEQ and delayFIR-Drive linear-phase processingProtection against over-temperature, DC, HF, back-EMF and peak current, plus inrush limiting and turn-on delayFront-to-rear cooling with three-stage fansControlled and configured with Dynacord system software SpecificationsOutput power, both channels driven2 ohm: 1000W, 2.6 ohm: 850W, 4 ohm: 600W, 8 ohm: 320WOutput power, single channel2 ohm: 1100W, 4 ohm: 660W, 8 ohm: 350WBridged output4 ohm: 2000W, 8 ohm: 1200WOutput stageClass ABFrequency response10 Hz to 21 kHz (±1 dB)Signal-to-noise ratio>104 dB (A-weighted)Voltage gain32 dBMaximum input level+21 dBuInput impedance20 kohm, active balancedCrosstalk< -80 dB (1 kHz, 100W into 4 ohms)Power consumption550W at 1/8 maximum output into 4 ohmsCoolingFront to rear, three-stage fansDimensions (H x W x D)88 x 483 x 462.4 mm, 2U rackWeight12.9 kgShow more

from £670.00

1 offer

See all offers