Lumines

LED PRO G double-ended connector for 12 mm RGB+CCT strips, 6PIN, without cable

Name: LED PRO G double-ended connector for 12 mm RGB+CCT strips, 6PIN, without cable
Brand: Lumines

LED PRO G 24-0000-70 is a double-ended connector for joining 12 mm RGB+CCT LED strips. It has six contacts and no cable between its two sides, bringing the strip ends together directly. The transparent housing is made from polycarbonate, with copper conducting parts.Check the strip and the connection spaceMatch both the strip width and its six contact pads when selecting this connector. This version is intended for 12 mm RGB+CCT strips. Compare the 22 × 17 × 7 mm housing with the space available at the planned joint.The pins pierce the strip's PCB to make a solder-free connection. Because there is no intermediate cable, this version does not bridge a gap between separated strip sections. The manufacturer specifies 5, 12 and 24 V DC and a maximum current of 2 A. That is a current limit, not a power rating in watts.Using IP20 and IP65 stripsThe connector can be used with both IP20 and IP65 strips. For IP65, closing the housing alone does not retain the protection rating: the joint must be sealed. This accessory therefore does not, by itself, establish water protection for the complete installation.Näytä lisää

alk. 0,73 €

1 tarjous

Näytä tarjoukset